Brillman had the color of wires tractor owner wanted. Got connectors and boots also.

What would be the correct Brass Patent Plate number? For cat ten serial no. 2829?

these ones:

MARCOTEN, could you check the plate # located in the lower right corner of each one near the attaching rivet? They should be numbers similar in format to 3606-A, 3393-A, V-258, etc. That will further pin down exactly which ones they are.

www.acmoc.org/bb/showthread.php?26106-Br...&p=173472#post173472

Cutting Ignition wires to fit on magneto.
And looking for spark plugs. No Autolite 3077 so far.
www.acmoc.org/bb/showthread.php?26102-Ca...&p=173474#post173474

www.acmoc.org/bb/attachment.php?attachmentid=62794&d=1473799085
Got surprised that the wires go into magneto without brass tip.
The previous Bosch mag have metal contacts that match the brass end clips for the wires. Took the plate of the magneto to have a close look and discovered that the wire in the cable has to center into the recess and is a friction fit onto the plate.

i checked the numbers on the plates :instructions pate : T-508
and small plate with us patends : 1A373

Thanks for checking plate nos.

Cat 15 magneto - Page 2
www.acmoc.org/bb/showthread.php?26102-Ca...&p=173520#post173520

Clockwise from 1, is 3, then 4, then 2?

attachment.php (800×764)
www.acmoc.org/bb/attachment.php?attachmentid=62809&d=1473894508

yes fireing order is 1-3-4-2