acmoc

ACMOC Membership Benefits

  • FREE quarterly magazine filled with content about antique Caterpillar machines
  • FREE classified listings
  • ACMOC store discounts and specials
  • Full Bulletin Board Access
    • Marketplace (For Sale/Wanted)
    • Technical Library
    • Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

Those dump trucks really do articulate !

More
17 years 1 week ago #9471 by gauntjoh
Whilst waiting to start a tour of Antwerp Docks this week, I saw the following..... I actually saw the truck overturn (I cringed when I saw the driver start to tip as the body was already leaning over at an alarming angle, I thought...no one could be so stupid as to try and tip in that position.....), but didn't catch it on film :confused:

The misadventure didn't seem to do it any harm, as it was back at work almost straight away.

I also visited a very nice collection of tractors near Kortrijk in Belgium, many old NA Prairie tractors, Lanz and Deutz, but no yellow iron :( Will post some pictures of them if anyone is interested.

John Gaunt, ACMOC President and Director, UK
Attachments:

Please Log in or Create an account to join the conversation.

More
17 years 1 week ago #9472 by ol Grump
Yup. .those Catwagons aren't only end dump. .;) I drove a Cat 250 at a mine near here a few years ago and while I didn't deliberately lay the box on it's side, what I was driving on did give way and over it went. Same thing, a quick visit from the excavator and it was back upright and away we went for another load.

While dumping sideways isn't the preferred way to do it, it doesn't seem to hurt 'em. A few scratches in the box from the excavator bucket seem to be the only permanent results, plus the pucker in the seat from the operator:eek: . .

Please Log in or Create an account to join the conversation.

More
17 years 6 days ago #9524 by drujinin
Replied by drujinin on topic You'd think....
You'd think something would break?

Please Log in or Create an account to join the conversation.

More
17 years 4 days ago #9569 by bordercollie
they have a pivot ring just behind the cab. Allows them to go over but not 360*. Hyd lines and electrical would be torn up. This "USUALLY" keeps the operator upright and lets the box go over. When tipping them back upright be careful not to grab ahold of the tailgate linkage with the excavator, this messes it up bad......... (had to repair a few before the excavator operator got it figured out, LOL)

Please Log in or Create an account to join the conversation.

More
17 years 3 days ago #9578 by Walt66A
It seems to happen often and most of the time, there isn't much damage. Somewhere, I have a pic of one where the load stuck in the box when they went to dump. When they raised the box, it picked the cab off of the ground, which caused it to flip around. The back half is upright, and the cab is upside down! Nobody got hurt - thank goodness for seat belts! I'll have to dig around at home to see if I can find it.

Please Log in or Create an account to join the conversation.

More
17 years 3 days ago #9580 by bob
I know a guy that used to flip the box over with a hoe to change the drive shaft spiders, then flip it back up when finished.
Later Bob

Please Log in or Create an account to join the conversation.

Time to create page: 0.149 seconds
Go to top